Edge Bander & Heat Transfer Machine

Origin	Korea
Model Number	SHET-6150AF
Brand Name	TERRA

Process :

Alter cutter(1st,2nd) → Glue zone(adhesion) → 1st end-cutting(side type) → Knife trim → Motor trim → 2nd end-cutting(side type) → buffing → Side-brush → 1st adhesive Tape → 2nd adhesive, adhesive strengthening

• Dimensions (L x W x H) : 6700 x 4500 x 1500
• Feed speed : 8M/min(Heat transcription), 14M/min (Edge banding) 5.5M/min (Heat trans)
• Temperature (Glue) : (Check the recommended temperature of manufacturers needed)
• Temperature(Heat transcription : Contact the vendor, depending on the transfer-tape)
• Recommended Pneumatic : 7kg/cm2
• Alter Cut - motor : 3kw High-frequency motor
• Glue container capacity : Standard - 4��( Large - 6��- optional)
• Mainly motor : 3.75kw~7.5k
• Capacitive (220V~380V, 3-phase) : 18kw
• Pannel width : 270mm~2,400mm
• Pannel length : 80mm~1,200mm
• Overhang : 35mm
• Pannel Thickness : 9~50mm
• Edge Thickness : 0.3~1mm
• Operating the device : Touch screen, select each individual Unit / behavior can be (select the features you want to use the operation)
• Attach oil supply : glue-zone manual refueling device

1. Flock of the glue-zone to compensate for a flaw in this cycle, and a thick panel preferred Excellence work.
2. Sink, OA furniture, interior and widely used in the field of operations far faster rate.
3. The wealth of touch-screen mounted manipulating the one-touch switch panel to manipulate everyone is simple and easy to use.
4. Trim the top and bottom of the special design the motor when the operation was to supplement the dust collection problems. Diamond coated cutters equipped with a far longer be used.
5. Equipped with cutting Alter Cutter when the material(P.B, MDF) is broken, so the adhesive after cutting the phenomenon can produce a clean product. (Optional)
6. Glue volume control device - equipped with automatic control devices, working with the PB and MDF products are clean and convenient. (Optional)
7. To install metal detection sensors, PB in the cutting operation to detect the metal to protect Alter Cutter.(Optional)
8. installation covered by the glue-zone and outside of the cold winter air blocking adhesion, glue-zone from the adhesive part of the column to maintain a warm environment, strengthen the adhesion was.
9. end-cut unit: Using the product into the side-type 150mm to a short interval, and improve operations introduced, is cutting a clean winter is not breaking even never. (Registered Patent)
10. Depending on the thickness of the automatic settings(12 ~ 50T), so it is easy for beginners to use
11. 'Edge-tape' adhesion after 'HEAT-TRANSFER' to clean and paint, so I can get a replacement effect is to produce high-quality products.